Type of pin-holder/cap to use on BL10
PLEASE NOTE: the informations below are
for BL10 and MAR Sample Changer only and they are different from BL14.2
ones.
Please refer to BL14.2
station manual for the RIGAKU robot.
Read Me
BL10 standard pin-holder/cap
is the type MAR-SPINE (C-batch-series) combined with 18mm cut Hampton pin.
This can be used either for manual or automatic (with MAR CSC) mounting. However
for manual mounting you can also use Hampton Crystal Cap Magnetic
or Oxford flat cap with the provided adaptor (no limitation in the pin length).
We do not support the plastic Hampton cap (they are not easy to mount and remove
with this system). Any custom made cap is likely not to be supported.
CAPS proved to work on Station 10.1 Sample Changer can be bought from: MAR Research (PDF brochure)
The adaptors can be found at the station in the preparation area:
| Type of Cap | Adaptor | Sample Changer | Manual Mounting |
 MAR-SPINE (C-batch-series) |
not needed |
yes |
yes |
 Hampton Crystal cap magnetic |
|
no |
yes |
 Hampton Crystal cap Copper magnetic |
|
no |
yes |
 Oxford metal cap |
|
no |
yes |
 Hampton Crystal cap™ Copper Plastic threaded |
|
no |
yes |
 Hampton Crystal cap™ Plastic threaded |
|
no |
yes |
MAR-SPINE (C-batch-series) can be ordered from:
marresearch GmbH
Hans-Beer-Ring 17
22851 Norderstedt
Germany
Email: info@marresearch.com
Tel: +49 (40) 529-884-0
FAX: +49 (40) 529-884-20
http://www.marresearch.co
